Dafo Fomtec EnviroSenze 2500

Technical Specification

Dafo Fomtec
  • Dafo Fomtec
Features:
  • Make: Dafo Fomtec
  • Model code: EnviroSenze 2500
Additional info:

EnviroSenze 2500 is an environment-tally friendly foam mimic concentrate with non-foaming properties. It is designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside. The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water.The viscosity of EnviroSenze 2500 is set be around 2500 mPas. This mimics an alcohol resistant foam concentrate in the lower viscosity range. The viscosity will not be exactly 2500 mPas, but rather around this value. The viscosity can vary from batch to batch between 1500 and 3000 mPas. Since viscosity also changes by temperature it is advisable to always measure the viscosity of the foam mimic solution before use.

Read more
Contact manufacturer Contact manufacturer Datasheet Datasheet
Make Dafo Fomtec
Manufacturer Dafo Fomtec AB
Category Fire and Rescue>Foam Equipment
Model code EnviroSenze 2500
Additional info
EnviroSenze 2500 is an environment-tally friendly foam mimic concentrate with non-foaming properties. It is designed to be used when testing and commission foam systems. The foam mimic concentrate has been designed to have similar flow behaviour as traditional foam concentrate but has no foaming agents inside.
The foam mimic concentrate can also be used to determine induction ratio as measured by conductivity. The same foam mimic concentrate can be used for 1%, 3% and 6% systems. The lower detection limit is around 0,2% induction using ordinary tap water.
The viscosity of EnviroSenze 2500 is set be around 2500 mPas. This mimics an alcohol resistant foam concentrate in the lower viscosity range. The viscosity will not be exactly 2500 mPas, but rather around this value. The viscosity can vary from batch to batch between 1500 and 3000 mPas. Since viscosity also changes by temperature it is advisable to always measure the viscosity of the foam mimic solution before use.
Download PDF version Download PDF version
vfd