Staffordshire Fire & Rescue Service - Experts & Thought Leaders

The fire protection industry is amid some exciting technological developments. While the core tenets of fire protection remain the same, new products allow for solutions that are more efficient and sustainable, not to mention safer. In this article, CLM will highlight some of the most recent advances in fire protection technology, and how they can transform the industry. SCot in fire protection The Internet of Things (IoT) has the potential to revolutionize everyday objects. In essence, the technology uses the internet to expand the capabilities of many products and appliances. Driverless cars are a common example of what have been described as Smart Connected Things (SCot). Smart technology is set to thoroughly modernize how fires are detected currently. Smart buildings These sensors could potentially detect the presence of fire before traditional smoke alarms Recently, CLM has seen an increase in ‘smart buildings’. In 2016, it was estimated that smart buildings hosted a total of 5 million connections. This is expected to increase to over 150 million connections by 2025. Going forward, many of these smart buildings will offer cutting-edge fire detection systems. These systems use sensors to read a building’s temperature with greater precision. These sensors could potentially detect the presence of fire before traditional smoke alarms. They may also be able to accurately gauge the intensity of a fire, alerting firefighters so they are appropriately prepared to tackle the blaze. an interconnected system of alarms Many conventional fire protection systems rely on an interconnected system of alarms. These are often installed by different manufacturers, with each one having different requirements for monitoring and maintenance. Smart buildings could not only offer superior levels of fire detection but also a centralized system in which an entire fire protection system is handled automatically by one computer. While this would necessitate a backup system in case of technical issues, this stands to make a building’s fire protection system as a whole more efficient. Water mist suppression Water sprinklers are a key asset for both commercial and residential fire protection Water sprinklers are a key asset for both commercial and residential fire protection. However, they arguably use too much water to be considered a sustainable solution. It should be noted that, according to the Staffordshire Fire and Rescue Service, the average sprinkler dispenses 55 liters of water per minute compared to the 750 liters dispensed by the typical fire hose. Fire sprinklers also pose problems for buildings that host fragile equipment, electronics, and perishable valuables. This, combined with an increased focus on sustainability, has prompted research into the benefits of water mist suppression systems. Benefits and working These systems work by creating droplets that are much smaller in size than those produced by conventional sprinklers. This not only reduces water usage but increases the surface area of water being dispensed. Fires feed on oxygen, and by replacing oxygen with steam, mist suppression systems reduce the overall temperature at a faster rate. This is not the only benefit offered by mist suppression systems. By creating a thin layer of water on affected walls, the rate at which fire spreads is reduced. Reduced rate of deaths By curtailing the spread of smoke, mist suppression systems can reduce the rate of deaths from smoke inhalation These systems also drastically lower the potential for smoke inhalation. Traditional sprinklers produce large water particles that become infused with smoke particles, which then cause smoke to spread. By curtailing the spread of smoke, mist suppression systems can reduce the rate of deaths from smoke inhalation, which make up over half of all fire-related fatalities (even this is a conservative estimate). The development of water mist systems had stalled for quite some time. This is due to a lack of similar industry technology, which complicated the process of setting technical standards. However, over the last few years, the technology has started becoming commercially available. “Green” fire-stopping sealants Fire stopping is a fundamental element of any passive fire protection system. This process involves using sealants to rectify any breaches in walls, floors, or ceiling voids that may enable the spread of smoke. There is a range of sealants currently available on the market, including silicone, MSP, butyl, and acrylic-based products. However, some of these products have been known to contain volatile organic compounds (VOCs). Volatile Organic Compounds (VOCs) Prolonged exposure to VOCs can cause chronic headaches, visual impairment VOCs can emit gases that are harmful to the environment, not to mention they contain multiple health risks. Prolonged exposure to VOCs can cause chronic headaches, visual impairment, and even memory loss. Therefore, fire protection companies need to embrace non-toxic and environmentally safe sealants. Protecta® FR IPT CLM Fireproofing is one of several companies to use Protecta® FR IPT, a VOC-free sealant that utilizes an innovative Inert Polymer Technology. This technology means there are no chemical reactions when applying the sealant. It is these chemical reactions that emit pollutants and hazardous gases. This lack of reaction also makes the sealant compatible with many construction materials, whilst also outperforming its less sustainable counterparts. Since this “green” sealant can be used on flooring, joinery, plumbing, and tiling (to name a few), it also reduces the amount of waste that comes with using multiple products. New guidance for sealing sprinklers New industry regulations may also, at times, prompt investment in new products and systems In the fire industry, there can be many catalysts for technological advancement. While CLM is always looking for ways to make processes safer and more efficient, it must also keep abreast of new fire safety regulations. Not only does this ensure the well-being of both residents and operatives, but new industry regulations may also, at times, prompt investment in new products and systems. Approved Document B updates For instance, the Ministry of Housing, Government & Local Government has announced updates to Approved Document B (Fire Safety) which will go into effect from November 2020 (and projects where building work starts after January 2021). These updates apply to blocks of flats (as well as mixed-use buildings that contain flats) that have top floors over 11 meters above ground level. Reduced threshold The most notable update is the height threshold for sprinkler systems in residential blocks of flats, which has been reduced from 30 to 11 meters. The reduced threshold means that C-PVC sprinkler pipes must be sealed with specialist-approved products. CLM strongly advises that operatives and project managers consult the following sources for guidance on sealants that comply with these new regulations: Lubrizol’s FBC™ System Compatible Program Spears’ FlameGuard® Compatible Products List Advanced smoke detection systems Smoke detectors remain a critical part of fire protection, but they can be unfortunately considered a nuisance Smoke detectors remain a critical part of fire protection, but they can be unfortunately considered a nuisance in many homes. This is because traditional smoke detectors can struggle to differentiate between ‘real’ fires and, for instance, the smoke created when cooking. This leads to smoke detectors being disconnected due to being ‘too sensitive’. Challenges with smoke detectors According to a study of U.S. homes conducted by the National Fire Protection Association, in fires with smoke detectors that were installed but failed to work, 43% were found to have missing or disconnected batteries. This shows more than anything that this common practice mustn’t continue. CLM can continue to encourage homes to keep their smoke detectors connected, but this does not address the cause of the issue. Instead, CLM must develop systems with more nuanced smoke detection capabilities. Need for a new smoke alarm While all of these situations will likely trigger a smoke alarm, each produces smoke particles of varying sizes One example of this is a new smoke alarm developed by Kidde, one of the world’s pioneering providers of fire safety technology. In 2019, it was announced that their smoke alarms would be equipped with TruSense technology. Smoke can be produced in a variety of household situations, from a fire to cooking as well as smoking cigarettes indoors. While all of these situations will likely trigger a smoke alarm, each produces smoke particles of varying sizes. TrueSense alarms  TrueSense alarms have been trained by algorithms to differentiate sources of smoke, based on the size of the particles. This then reduces the amount of ‘false alarms’, deterring households from disconnecting their smoke detector. These types of systems certainly have potential for residential homes. Requirements for commercial buildings However, CLM must also consider the unique requirements of commercial buildings at risk from fire. Warehouses, depots, and large storage facilities are expansive spaces with higher ceilings than the average home. This means there is a risk of fire damage before the smoke reaches the detectors. It should also be taken into account that commercial buildings will usually have more than one smoke detector. This means that fire protection systems may raise the alarm without knowing the exact location of a fire. Visual image detection (VID) technology These unique issues can be addressed with visual image detection (VID) technology. Cameras are installed and then linked to a piece of VID software on a central computer. The software utilizes algorithms, which have been programmed to recognize pixels indicative of either smoke or fire. The computer then triggers an alarm system that can contact the local fire department, while also initiating fire sprinkler and door systems. VID systems act as advanced and automated fire detectors, and can often identify the exact source of a fire.

The number of Police Fire and Crime Commissioners could rise after the PCC elections on 6 May, as the UK Government indicates strong support for this type of governance. Currently, there are four Police Fire and Crime Commissioners in England: Staffordshire Essex Northamptonshire North Yorkshire Julia Mulligan is stepping down in North Yorkshire and Mathew Ellis is likewise in Staffordshire. PCC elections Other PCCs have shown interest in taking on governance in the fire but have been unable to clear all the hurdles. The government halted any further progress during the COVID-19 pandemic and has been waiting for the PCC elections to take place. Martin Surl is the Independent PCC for Gloucestershire and is standing for re-election. He will restart his bid to take on fire in the county should he win on Thursday. Conservative PCC The government has already made it clear that it favors the PFCC model The Conservative PCC for West Mercia remains determined to take over the governance of fire and rescue in Shropshire and Hereford and Worcestershire. Both candidates faced fierce local opposition to the takeovers. Other PCCs who showed interest in taking on fire governance include Cambridgeshire, Hertfordshire, Norfolk, Surrey, Suffolk, and Lancashire. The government has already made it clear that it favors the PFCC model. proposals In a review of PCCs published in March, the Home Secretary indicated that governance would be a key part of the promised fire reform white paper. The government said that the proposals would include: Consulting on whether to mandate the transfer of fire and rescue functions to the Police, Fire and Crime Commissioner model across England where boundaries are coterminous unless there is an option to transfer fire governance directly to an elected Mayor. Consulting on how to address coterminosity challenges, including in the South West. Legislating to create operational independence for Chief Fire Officers and to clearly separate and delineate strategic and operational planning for fire and rescue. Considering options to clarify the legal entities within the PFCC model.

BAFSA is disappointed to report that, along with Staffordshire Fire & Rescue Service and Dorset and Wiltshire Fire & Rescue Service & BAFSA, the organizations have made the difficult decision to postpone their joint sprinkler seminars on 18th and 24th March respectively due to the current Covid-19 fears. While disappointing for everyone involved, they have taken this step in line with NFCC guidance as far as reducing the chance of spreading the virus as much as is reasonably practicable. They will reorganize these seminars and post the updates for the same on the company’s official website.