Kidde Fire Systems KN-COPE-IC Firex™ AC Hardwired Combination Carbon Monoxide & Photoelectric Smoke Alarm

Technical Specification

Features:
  • Make: Kidde Fire Systems
  • Model code: KN-COPE-IC
  • Style: Photoelectric
  • Type: Smoke
Additional info:

AC-Wire with battery backup - Powered by home’s electricity in order to provide continuous protection. An included 9V battery protects during short-term power outages. Front-Loading Battery - Speeds up replacement by eliminating the need to remove the unit from the ceiling or wall. Unique Battery Door Design - Will not close if battery is not installed properly. Voice Warning - Supplements warning from the traditional 85-decibel alarm by clearly stating the danger present, fire or carbon monoxide. Photoelectric smoke sensor - May detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor. Electrochemical CO sensor - Provides accurate and continual CO protection during the product’s life, remains stable during temperature and humidity changes and resists reactions to household gases that may cause false readings or reduce sensitivity. Smart Touch Button - One button performs the following functions: Activates the Hush® feature to temporarily silence nuisance alarms (will announce “Hush mode activated,” or “Hush mode cancelled.”) Simultaneously tests the unit’s electronics and verifies proper operation Activates the peak level memory feature (will announce, “CO previously detected” if unit has detected levels of 100 ppm or higher) Resets the unit during a CO alarm (Unit will re-enter alarm within 6 minutes of reset if 70ppm or more of CO is present). Silences a low battery chirp for up to 12 hours Silences the end of life chirp for two days Announces, “CARBON MONOXIDE PREVIOUSLY DETECTED” if alarm has detected a CO level of 100ppm or higher since it was last reset. Silences nuisance alarms for approximately 9 minutes. (Smoke must be present before HushTM is activated) Tamper Resistant Green LED - Will flash every 30 seconds to indicate proper operation. Red LED – Flashes in conjunction with the alarm sounding. End of Life Signal - Ten years after initial power, the unit will “chirp” twice every 30 seconds to indicate the need to immediately replace the alarm. Low Battery Signal - Will chirp every minute and red LED will flash to indicate low battery condition. Interconnectable - Will interconnect with up to 24 other devices (18 of which can be initiating) including smoke, CO and heat alarms.

Read more
Make Kidde Fire Systems
Manufacturer Kidde Fire Systems
Model code KN-COPE-IC
Style Photoelectric
Type Smoke
Additional info
  • AC-Wire with battery backup - Powered by home’s electricity in order to provide continuous protection. An included 9V battery protects during short-term power outages.
  • Front-Loading Battery - Speeds up replacement by eliminating the need to remove the unit from the ceiling or wall.
  • Unique Battery Door Design - Will not close if battery is not installed properly.
  • Voice Warning - Supplements warning from the traditional 85-decibel alarm by clearly stating the danger present, fire or carbon monoxide.
  • Photoelectric smoke sensor - May detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor.
  • Electrochemical CO sensor - Provides accurate and continual CO protection during the product’s life, remains stable during temperature and humidity changes and resists reactions to household gases that may cause false readings or reduce sensitivity.
  • Smart Touch Button - One button performs the following functions:
    • Activates the Hush® feature to temporarily silence nuisance alarms (will announce “Hush mode activated,” or “Hush mode cancelled.”)
    • Simultaneously tests the unit’s electronics and verifies proper operation
    • Activates the peak level memory feature (will announce, “CO previously detected” if unit has detected levels of 100 ppm or higher)
    • Resets the unit during a CO alarm (Unit will re-enter alarm within 6 minutes of reset if 70ppm or more of CO is present).
    • Silences a low battery chirp for up to 12 hours
    • Silences the end of life chirp for two days
    • Announces, “CARBON MONOXIDE PREVIOUSLY DETECTED” if alarm has detected a CO level of 100ppm or higher since it was last reset.
    • Silences nuisance alarms for approximately 9 minutes. (Smoke must be present before HushTM is activated)
  • Tamper Resistant
  • Green LED - Will flash every 30 seconds to indicate proper operation.
  • Red LED – Flashes in conjunction with the alarm sounding.
  • End of Life Signal - Ten years after initial power, the unit will “chirp” twice every 30 seconds to indicate the need to immediately replace the alarm.
  • Low Battery Signal - Will chirp every minute and red LED will flash to indicate low battery condition.
  • Interconnectable - Will interconnect with up to 24 other devices (18 of which can be initiating) including smoke, CO and heat alarms.
Download PDF version Download PDF version
vfd